i can't get response of "get_next_pass".

Follow

Makesh Sutariya

• July 19, 2019 06:10

Respected Sir,

i have a Hiber development kit.. It's GAMMA version which is supported Arduino Mega 2560 board.(with antenna)
also, it's with updated firmware version 1.2...

Now, Gamma kit have not Built in GPS as per your forum..
so, i updated location and time manually by using UART API. but i can't got response of "get_next_pass"..

response shows like := API(600: -1)  // i think it's wrong value.

can you guide me for proper way for setup location and time manually by UART API.. and i want to got a proper response of "get_next_pass" command. response should be in Seconds. 

Thank you
Mahesh Sutariya

0

• Official comment

  

  Permanently deleted user

  • July 22, 2019 08:35

  Hello Mahesh,
  
  Thank you for your message!
  
  The response of -1 means a next pass is not set yet. The modem needs to receive a satellite broadcast at least once in order to calculate the next satellite pass. I have updated the documentation to reflect this, as this piece of information was missing. Thank you for bringing this to our attention!
  
  At the moment we are still going through the commissioning process of our satellite network, which means you will not be able to receive a broadcast right now. This also means the modem cannot calculate when the next pass will be at this moment.

  Kind regards,

  Sven

  Comment actions Permalink
• 

  Mohammed Elbakh

  • January 31, 2020 09:31

  Hey Sven,
  
  Are the satellites able to broadcast now?
  
  Mohammed El Bakh

  0

  Comment actions Permalink
• 

  Permanently deleted user

  • February 01, 2020 15:06

  Hi Mohammed, 

  Yes, the satellites are active, although not continuously yet at this moment.

  Currently, we are still limiting network activity to our internal tests only. We will keep you informed on when you can perform your own tests over the network.

  Thank you!

  Sven

  0

  Comment actions Permalink

Please sign in to leave a comment.